Audio Technica AT-VM95E/H: VM95 series elliptical stylus stereo cartridge mounted on an AT-HS6 head
VM95 series elliptical stylus stereo cartridge mounted on an AT-HS6 headshell.
The AT-VM95E/H is a VM95 series cartridge/head unit consisting of the AT-VM95E elliptical stylus stereo cartridge mounted on an AT-HS6BK head. The total weight of the assembly is 15.5 grams and it is assembled and tested at the Audio-Technica factory in Fukui, Japan.
Characteristic:
VM95 series elliptical stereo capsule in an AT-HS6 head
AT-VM95E mounted on an AT-HSBK head
The total weight of the set is 15 g
Assembled and tested at the Auido-Technica factory in Fukui, Japan
VM95 Series - Stylus Compatibility
Every diamond stylus in a capsule wears after a period of work.
Around 500 hours for a conical stylus, 300 hours for an elliptical stylus, 1000 hours for a Microlinear stylus, and 800 hours for a Shibata stylus.
Our VM95 series dual moving magnet cartridges can be used virtually forever if the interchangeable stylus is replaced. It is no longer necessary to purchase a full capsule when the diamond tip has been worn down; you just have to purchase the right replacement stylus, but you can also enjoy the experience of upgrading your cartridge with a different stylus.
The six capsule models that make up the VM95 series use the same electromagnetic motor body, therefore each of the six replacement needles is perfectly compatible:
AT-VMN95C
AT-VMN95E
AT-VMN95EN
AT-VMN95ML
AT-VMN95SH
AT-VMN95SP
Elliptical needle stuck
The elliptical diamond stylus follows the groove modulation more precisely compared to the conical stylus, offering better frequency and phase response while reducing distortion.
Pre-assembled with AT-HS6BK head
The AT-VM95E capsule is fixed in the aluminum body of the head, 9 gr.
Technical characteristics:
TYPE: Stereo double magnet VM
MOUNTING: 1/2" Between Centers
FREQUENCY RESPONSE: 20 - 22,000 Hz
CHANNEL SEPARATION: 20 dB (1 kHz)
OUTPUT CHANNEL BALANCE: 2 dB (1 kHz)
OUTPUT VOLTAGE: 4.0 mV (1 kHz and 5 cm/s)
VERTICAL TRACKING ANGLE: 23°
VERTICAL TRACKING FORCE RANGE: 1.8 - 2.2g (2.0g standard)
NEEDLE SHAPE: Elliptical
NEEDLE SIZE: 0.3 x 0.7 mil
NEEDLE CONSTRUCTION: Fixed diamond stylus on rounded shank
CANTILEVER: Aluminum tube
RECOMMENDED LOAD IMPEDANCE: 47,000 Ω
COIL IMPEDANCE: 3.3 kΩ (1 kHz)
COIL INDUCTANCE: 550 mH (1 kHz)
DC RESISTANCE: 485 Ohms
STATIC COMPLIANCE: 17 × 10-6 cm/dyne
DYNAMIC CONFORMITY: 7 × 10-6 cm/dyne (100Hz)
RECOMMENDED LOAD CAPACITANCE: 100-200 pF
WEIGHT: 15.5g
DIMENSIONS: 21.2 mm (Height) x 21.4 mm (Width) x 62.4 mm (Depth)
SPARE NEEDLE AT-VMN95E
CABLE USED FOR T.P. COIL Copper