Audio Technica AT-VM95SP: Dual Moving Magnet Cartridge for 78rpm Mono Records
This VM95 series cartridge with a 3 mil tapered stylus can be used with half-inch mount turntables. While it is designed to play 78rpm mono records, it is, however, a stereo cartridge, allowing users to choose between left and right channels, which can be especially useful in archival applications to minimize noise. noise and distortion. The rugged, low-resonance housing features threaded inserts that allow the cartridge to be mounted to the headstock with just two screws, without the need for nuts. And since the entire VM95 series shares the same body, the stylus can be replaced with any of the six interchangeable AT-VMN95 replacement styli.
Characteristic:
VM95 series dual magnet cartridge with 3 mil tapered stylus for 78 rpm records
aluminum cantilever
Low Resonance Rugged Polymer Housing
Threaded insert in the body of the capsule that allows it to be mounted on the head with only two screws, without the need for nuts or washers
Compatible with any AT-VMN95 replacement needle
VM95 Series - Stylus Compatibility
Every diamond stylus in a capsule wears after a period of work.
Around 500 hours for a conical stylus, 300 hours for an elliptical stylus, 1000 hours for a Microlinear stylus, and 800 hours for a Shibata stylus.
Our VM95 series dual moving magnet cartridges can be used virtually forever if the interchangeable stylus is replaced. It is no longer necessary to purchase a full capsule when the diamond tip has been worn down; you just have to buy the right replacement stylus, but you can also enjoy the experience of upgrading your cartridge with a different stylus.
All six cartridge models that make up the VM95 series use the same electromagnetic motor body, therefore each of the six replacement styli is perfectly compatible.
Technical characteristics:
TYPE: Stereo double magnet VM
MOUNTING: 1/2" Between Centers
FREQUENCY RESPONSE: 20 - 20,000 Hz
OUTPUT CHANNEL BALANCE: 1.5 dB (1 kHz)
OUTPUT VOLTAGE: 2.7 mV (1 kHz and 5 cm/s)
VERTICAL TRACKING ANGLE: 23°
VERTICAL TRACKING FORCE RANGE: 4.5 - 5.5g (5g standard)
NEEDLE SHAPE: Tapered
NEEDLE SIZE: 3.0 mil
NEEDLE CONSTRUCTION: Bonded Round Shank
CANTILEVER: Aluminum tube
RECOMMENDED LOAD IMPEDANCE: 47,000 ohms
COIL IMPEDANCE: 3.3 kohms (1 kHz)
COIL INDUCTANCE: 550 mH (1 kHz)
RESISTANCE: 485 ohms
STATIC COMPLIANCE: 12 × 10-6 cm/dyne
DYNAMIC CONFORMITY: 2 × 10-6 cm/dyne (100 Hz)
CABLE: T.P. Copper
RECOMMENDED LOAD CAPACITANCE: 100-200 pF
DIMENSIONS: 17.2 mm (Height) x 18.9 mm (Width) x 28.3 mm (Depth)
WEIGHT: 6.1g
SPARE NEEDLE AT-VM95SP
ACCESSORIES INCLUDED:
Two 11mm mounting bolts, two 8mm mounting bolts, two washers