Revolutionary in automation, the LP3 combines stunning analog sound with advanced features unique in a fully automatic belt-drive turntable. It plays 33⅓ and 45 RPM records with an AT91R Dual Moving Magnet phono cartridge, while the arm's detachable universal headstock and cartridge switching mode allow the listener to experiment with moving-coil and moving-magnet cartridges. Complete with a built-in phono preamp, the LP3 represents a higher level for vinyl lovers.
FEATURES
Fully automatic, belt-drive turntable with two speeds: 33-1/3, 45 RPM
Balanced straight arm with hydraulically damped lift control and locking bracket
Built-in switchable phono/line preamplifier with fixed dual RCA output cable
Switchable modes for moving coil and moving magnet cartridges
AT91R Dual Moving Magnet™ phono cartridge and AT-HS3 universal headshell
Anti-resonance cast aluminum platter with 4.5mm thick rubber mat
Damped base construction for less coloration due to low-frequency feedback
MM / MC CAPSULE SELECTOR
Switchable MM/MC mode allows the listener to use both moving magnet and moving coil cartridges on their LP3, allowing for greater sonic customization – a unique feature not found on most turntables with a built-in phono preamp.
SPECS
Giradiscos
Type Fully automatic, belt drive
Motor Motor DC
Speeds 33-1/3 RPM, 45 RPM
Turntable Cast aluminum
Weep & Flicker Less than 0.2% WRMS (33 1/3 RPM) at 3kHz
Signal-to-Noise Ratio > 60 dB
Output Level “PHONO” (MM) 3.5mV nominal at 1kHz, 5cm/sec
“LINE” (MC) 220mV nominal at 1kHz, 5cm/seg
Phono Pre-Amp Gain 36dB nominal, RIAA equalized
56dB nominal, RIAA equalized
Power Supply Requirements 220 to 240 V / 50, 60 Hz
Current Consumption 2W
Dimensions 435mm×353mm×128mm (W×D×H)
Weight 5.2kg
Included Accessories Rubber mat, dust cover, platter (with pull strap), counterweight, AT-HS3 head with AT91R VM stereo VM cartridge, 45 RPM adapter, power cord
capsules
Model AT91R
Type VM Double Magnet
Output Voltage 3.5mV (mV at 1kHz, 5 cm/sec)
Vertical Tracking Force Range 1.5 to 2.5g (standard 2.0g)
Needle Construction 0.6 mil glued taper
Cantilever Aluminum tube
Recommended Load Impedance 47,000 ohms
weight 5.0g
Head
Model AT-HS3
Weight 11.1g
Capsule advance adjustment 8mm
Arm
Tone Arm Type Static Balanced Straight with Soft Damping Control
Effective Length 221.5mm
Capsule advance adjustment 19mm
Maximum angle of following error Less than 3°
Stylus Pressure Adjustment Range 1 a 4g
Applicable capsule weight 14.5 to 20g
Anti-skating range 0 - 3 g