THE NEW MAIA S3

The MaiA S3 is the all-in-one solution for your hi-fi system. Not only has the circuit design been changed, the casing has also been significantly modified and the MaiA S3 uses our new S3 casing. Due to the larger size, we were able to improve the circuit board design in terms of electromagnetic interference. With its 8 inputs, it is ready for any type of source device.

Versatile and Compact

The MaiA S3 offers eight inputs. Ready for digital or analog sources, wired or wireless – you've got it covered. The phono section can handle high output MM, MI, or MC cartridges. Connect your tuner or any other analog device to one of the three line level RCA inputs. The DAC section allows for one coaxial and two optical connections. Wireless aptX™ HD Bluetooth 5.0 input lets you stream your favorite music through your phone.

Versatile inputs and outputs

Phone, Line, Digital, Bluetooth 5.0

Use your favorite headphones or connect your speakers with the 4mm banana plugs and the low noise amplifier will do the rest. The variable RCA output also allows you to include a subwoofer in your setup.

aptX™ HD

Bluetooth 5.0

aptX ™ HD with our new Bluetooth 5.0 chip will allow you convenient high resolution streaming from your smartphone.

Handmade in the EU

Since 1991

Made in Europe by technicians, engineers and designers with decades of experience. Expert craftsmanship. Sustainable products with a long shelf life. Audiophile audio performance.

Technical specifications:

Power output: 2x 23W / 40W at 8 / 4ohms (1% THD)

Frequency response (20Hz - 20kHz): <-0.5dB @4ohm

Channel separation: - 69dB at 10kHz

Signal to noise ratio: 97dB (101dB-‚A' weighted) @4ohm

THD: < 0.04% at 10W / 4 ohms

Headphone Amplifier: 2x 75mW at 32ohm (1% THD)

Headphone output: 6.3 mm jack (16 - 600 ohms)

Analog inputs: 3x RCA pair, 1x phono MM (RCA)

Digital inputs: Coaxial RCA, 2 x Toslink, Bluetooth 5.0 (aptX)

D/A converter: Cirrus Logic CS4344 24bit/192kHz

Variable output: 1x RCA pair

Speaker Connectors: 4mm Ø banana plugs, spade connectors or bare wire

Power supply: 20V/3A DC; 100 - 240V, 50/60Hz

Standby power consumption: <0.5 watts

Dimensions width x height x depth: 206x55x153 (176mm with bushings)

Battery Remote Control: 1 x CR2032/3V or CR2025/3V

Weight: 1070 g without power supply